jack up on the rear axle or on the ubolt plate
The owners manual shows the jack points. One on the front and rear sub frame for a floor jack. One below front and back door.I believe there is an arrow or notch made into the trim piece showing the jacking points. Always block the front or rear wheels. Be very careful if using the Toyota supplied jack. Floor jack and jack stands are preferable.
You can put the jack under the shock towers on the front, or the cross brace on the rear.
The safe jacking point on the new VW Beetle is at the drain plug. Use a square of plywood on the floor jack. The stand goes under the forward spring plate or under the round outer torsion bar.
front or either side of front of vehicle - position floor jack under front frame lift points rear or either side of rear of vehicle - position jack under the pinch point notches
The jacking points for the 944 are under the sill. if you look at the sill closely you will see a diamond shape pointing out where the jack should sit. be sure to use this point as you could buckle the floor or worse, put the jack right through the floor! it's the one point if you want the front or rear wheels jacked up.
You can jack from the sides, just behind the front tires (or in front of the rear tires) you will see two half circle notches in the metal frame, these are jack points, but if you have a suitable floor jack, its better to use the jack points on the bottom of the car (I've seen slight damage to the frame from jacking from the side, because the metal tabs can bend). The jack points on the bottom of the echo: FRONT - this one can be hard to find at first, look for the square slightly towards the drivers side about 3 feet back from the front of the car, there is nothing else under that that looks like a jack point, so you should be able to spot it. REAR - this one is easy to find, its a square right in the middle, all the way towards the back. Unfortunately many normal sized, inexpensive floor jacks will have a hard time reaching the front jack point while still giving you enough clearance to jack the car up.
I have heat in my truck all but the floor. this is a 1998 s-10 Chevy pickup. can you help me find out the reason?
To jack up a Chrysler Concorde, first ensure the vehicle is on a flat, stable surface and engage the parking brake. Locate the jacking points, typically found near the front and rear tires along the vehicle's frame. Use a hydraulic floor jack to lift the vehicle, placing it securely under the designated jacking points. Once elevated, insert jack stands for added safety before working underneath the car.
On my 88 Toyota 2WD pickup, some fuses are under the hood on the RH side behind the battery. Others, and the flasher relay, are inside the cab above the floor behind the kick panel on the LH side. Take out 2 screws that hold the kick panel on. There is a lid over the fuses with some of them labeled.
Under the glove box, look up under from the floor and you will see it bolted to the junction box, disconnect the battery then the wires to the fan, pull three bolts and out she comes
The 2001 Toyota RAV4 has .
One can purchase floor mats that would fit in a Toyota Tacoma by going to the Carid website. Also, AutoAnything and Amazon sell Toyota Tacoma floor mats too.