answersLogoWhite

0

What else can I help you with?

Related Questions

How do you replace rear disc pads on 1991 Lumina?

This was one of the worse designs gm ever built. After removing caliper the caliper piston winds in clockwise. There is a special tool to so this but you may be able to do it with adjustable pliers. Very often the caliper slide pins will be frozen solid. If this is the case do yourself a favor and go buy a reman loaded brake caliper will save a ton of time.


How do you take the front rotors off on a 2002 Dodge Ram 1500 2wd?

With tire removed you will need to unbolt the caliper which is held on by two bolts caliper bolts). Once the bolts are removed you should be able to dislodge the caliper by grasping the top and pulling back or by rocking from top and bottom. Secure the caliper with a hanger to the frame not the rubber lines, be careful the pads may come loose. You will now have to remove the the caliper bracket also attached by two bolts. Once the bracket is removed the rotors should slide right off the studs. If corrosion has built up lightly tap around rotor with rubber mallet or a piece of wood and hammer. GOOD LUCK!


Which animals has built-in rubber in its tail?

platypus


What Type Of Rear Brakes Does a 2008 Crhysler Town and Country have?

It has rear disc brakes with the parking brake built into the caliper.


How do you take the slack movement on back caliper on a mazda6 2003?

the piston must be screwed (turned) in to bottom out to accept new brake pads this is due to the integrated park brake mechanism built into caliper. there is a special tool that screws piston it can be done with water pump (channel lock )plyrs dont damage dust seal once job is done pull and release park brake handle about 15 time to self adjust excess space between pads and rotors g if caliper has excessive paly in the mounting pins buy a rebuilt loaded caliper from auto parts store cheaper then dealer


What would cause rear brakes to get abnormally hot and smell like burnt rubber after a break change on a 1995 240sx?

Sounds like possibly seized caliper sliders or the piston is not retracted far enough (assuming the car has disc brakes in the rear), if the parking brake actuator is built into the caliper on that model, you may have to rotate the piston back into the bore to release the park brake, if it has a separate park brake, make sure it is adjusted properly and the cables are not seized.


A special switch that uses a built in thermometer?

The answer is thermostat.


I have built an out door concrete pool What paint should I use Thanks?

either epoxy or chlorinated rubber


Who invented soccer ball?

In 1855, Charles Goodyear designed and built the first rubber soccer ball.


Does dry natural rubber contain latex?

Natural rubber is a polymer built up of isoprene units. Latex is found in nature. It comes from rubber tree (Hevea Brasiliensis). Latex coagulates naturally and turn into dry natural rubber. Normally, latex containing 25 to 40% of dry rubber.


How are Bradley Robinsons built?

They are built by hope tucker and bradley Robinson going out and they connect together and they special robinsons is made.


What special switch uses a built-in thermometer to control temperature?

volt