In the radiator. 50/50 mix = half antifreeze, half water
Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks
Around 100. You just have to know how to squeez them in there. You might have to put in a few upsidedown.
10.5 qts.
PUT IT IN THE RADIATOR. MAKE SURE YOUR ENGINE IS COOL AND USE THE DRAIN COCKPIT LOCATED ON THE BOTTOM OF YOUR RADIATOR TO DRAIN ENOUGH OF THE FLUID TO ACCOUNT FOR HOW MUCH ANTIFREEZE YOU ARE ADDING.
in the dip stick hole.
in the brake fluid reservoir, somewhere along the back of the engine bay. the cap will say something like "brake fluid dot 4 only"
Antifreeze has to be put in at the overflow bottle.
How can I repair the metal hose that is inside of the plastic cap and pulling the antifreeze but do not see where, and drips between monobloc and automatic transmission
It's an automatic. Leave it in "Drive" and the car will pick a suitable gear all by itself.
I went to Timsons to have a new betery put inkey fob he could not do it as it would wipe memory of key and the car would not start where do I now take key for battery change
Yes, with money everything is possible. The VG30DETT (top of the line engine in 300zx) has been put in several different Nissan car; and could be done in others.Easy ones: S13 (89-94 240sx), S14 (95-98 240sx), R32-34 (skyline gtst, gtr)Medium: Z33 (350z, G35)Hard: Nissan Micra, Pulsar, SentraAnything originally RWD will be easy, FWD HARD
i believe you can put the antifreeze anywhere in a jeep