on the left side of the transmission is a sensor. carefully remove it and pump/squeeze fluid in that opening up to the bottom of the hole. replace sensor.
On the 2002 Rodeo the transmission is sealed and is non servicable by the owner. You cannot even check the fluid level so I advise taking it to an Isuzu repair shop.
dextron or mercon III, you have to pump it in from the bottom.
P245/60R18 are the size tires needed for a 2002 Isuzu Rodeo. Michelin and Goodyear are great tires for the 2002 Isuzu Rodeo.
If your looking to change the oil in an Isuzu Rodeo 2002, a step by step procedure is available at [http://wiki.answers.com/Q/How_do_you_change_the_oil_on_a_2002_Isuzu_Rodeo]. Additionally, if you're looking to change the transmission fluid on this same vehicle, a detailed procedure is available at [http://wiki.answers.com/Q/How_do_you_change_the_transmission_fluid_on_an_automatic_2002_Isuzu_Rodeo].
Your 2002 Isuzu Rodeo may not be shifting due to several potential issues, such as low transmission fluid levels, a faulty transmission filter, or a malfunctioning shift solenoid. Electrical problems, like a damaged wiring harness or a defective transmission control module, can also prevent proper shifting. Additionally, a worn-out clutch or internal transmission damage may be to blame. It's best to have a professional diagnose the issue for accurate repairs.
there is no dip stick it is filled from underneath a lube shop will do it cheap don't wait if your transmission is slipping
how to change engine block sensor
No, they cannot because they are too heavy and dumb
cylinder one on a 2002 isuzu rodeo 3.2 engine is on center drivers side
There isn't a transmission dipstick. Auto mechanics have tools that will flush the transmission but other than that, there is no dipstick. There is a transmission pan under the truck where you can drain/flush your transmission.
there is none, it uses the same one in front
On a 2002 Isuzu Rodeo, the thermostat is located at the end of the top radiator hose on engine. It is situated under the intake manifold.