there may be a difference in 93-older tegs, but 94-newer you will find a breather on top of the transmission with a dime-sized rubber cap on it. remove this cap, and the way i fill the trans is place a rubber 3/8" hose over the end of a funnel, and the other end of the hose over the breather tube. the tranny takes 2 quarts total of 10w30 motor oil. this applies to ls,gs,rs, gsr, and itr, hydro manual transmissions ONLY! also there are two plugs on the side of the tranny; one to drain the oil, and one to check the level. hope this helped!
10w 40 is recommended if driving highway speed for prolonged periods.
don't know wat kind of fluid it takes 91acura integra ls
The 1997 Acura Integra typically uses Honda Manual Transmission Fluid (MTF) or an equivalent 10W-30 motor oil for its manual transmission. If the vehicle has an automatic transmission, it requires Honda ATF-Z1 or an equivalent automatic transmission fluid. Always check the owner's manual for specific recommendations to ensure optimal performance.
To add transmission fluid to a 1994 Acura Manual Integra, first locate the transmission fluid fill plug, which is typically found on the side of the transmission case. Remove the fill plug using the appropriate tool, then use a funnel or a fluid pump to add the recommended type of manual transmission fluid until it reaches the bottom of the fill hole. After adding the fluid, securely replace the fill plug and check for leaks. Always consult your owner's manual for specific fluid types and capacities.
There isn't a manual transmission fluid reservoir in an 95 Integra. The fluid is poured directly into the transmission case via the 17mm fill bolt, located at about 10 o'clock above where the passenger side drive shaft connects to the transmission, as looking at the end of the tranny.
8lts i think
If its a manual transmission any 5w-30 oil will work fine. However I personally use Honda's specific manual transmission fluid, available at any Honda dealership.
Dexron II ATF
10w40 4.8 pts.
If it is an automatic transmission, you add transmission fluid with a long funnel through the dipstick opening.
if its a manual transmission you dont have one it has a plug you unscrew and look into if its an automatic its on the passenger side(the side with the transmission) it will have a yellow handle on it.
To change the transmission oil on a 1988 Acura Integra drain the older fluid by loosening the drain bolt. Wait until it is done drain and cap the hole. Insert new transmission fluid in the transmission reservoir.
Usually thru the dipstick hole!