its next to the battery on the side of the fuse box.. should be a little box that says diagnostic.
where is the nock sensor on my 95 toyota 4runner
Code 41 Throttle position circuit fault
On a 1998 Toyota model, you can connect a code scanner to the OBD-II (On-Board Diagnostics) port, which is typically located under the dashboard near the driver's side, often just above the brake pedal. Look for a rectangular connector that may have a cover or panel. Ensure the vehicle is turned on (but the engine doesn't need to be running) to access the diagnostic data.
It could be a "slight" problem with the electronic sensors. If a "check engine" light is on, the computer has detected a problem with the sensors. You need to use a code scanner to detect the fault code.
You should check that. Connect a code scanner to find out what the light means. You can borrow, rent or buy a code scanner at most auto parts retailers. Some will even help you connect and read the code.
I have a 2008 toyota fielder and the engine check light came on .when check with a scanner code p1589 shows .where is this sensor located
You read the codes with a scanner, repair the cause, and clear the code with the scanner.
Trouble Code P1705 means:NC2 revolution sensor circuit malfunction
Remove the negative battery cable for 6 minutes and then replace.
The computer will tell you. If you have a "check engine" light, connect a code scanner to see what the computer has detected. If there is a problem with the oxygen sensor the code scanner will display the appropriate problem code.
Trouble code P1130 means: Air-Fuel Sensor Circuit Range/Performance
They have 2 white colors for the 1999 4Runner and this code does not tell which one it is?