The port is located under the dash on the drivers side. It is located to the right of the steering column. Should be black and pointing downward.
The OBD II port on a 1997 Toyota T100 pickup truck is typically located under the dashboard, near the driver's side. Specifically, it can be found to the left of the steering column, close to where the steering wheel meets the dashboard. You may need to remove a cover or look closely to spot it, as it can be somewhat hidden.
The 2003 Toyota Tundra OBD 2 port is under driver side dash above accelerator pedal
OBDII Port below dash/steering wheel.
its is located in right side of engine
The low pressure charging port for a 1986 Toyota four-cylinder truck is typically located on the larger of the two A/C lines, which is the suction line. This line usually runs from the evaporator to the compressor, and the port is often found near the compressor itself. Look for a blue or black cap on the line, which indicates the low pressure service port. Always ensure the vehicle is off and depressurized before attempting to service the A/C system.
The 1999 Toyota Tacoma OBD 2 port is on lower edge of dash; next to console; connector faces down
Does not have one, 96 had this port under the steering wheel. Yours is a OBD1 under the hood behind the battery.
On a 1993 Toyota T-100 truck, the OBD (On-Board Diagnostics) port is typically located under the dashboard, near the driver's side. You can find it above the brake pedal, mounted on the lower part of the dashboard. It may be covered by a small plastic panel, which you can remove to access the diagnostic connector.
It is on the accumulator.
The Diagnostic port, looking from front of vehicle, is located on the drivers side rear corner of the engine compartment
The Freon recharge port for a 95 Toyota Camry is located near the air conditioning compressor. It is near the fire wall, and has a black cap with an L marked on it.