Right side after cat converter
|Pin6 behind painel with odometer
Trouble code P0163 means:O2 sensor circuit low voltage (bank 2 sensor 3)
To remove the speedometer sensor from a 1998 Nissan Frontier, first, disconnect the negative battery terminal to prevent any electrical issues. Next, locate the speedometer sensor on the transmission, typically near the tail end. Remove the sensor's electrical connector and then unscrew the sensor using a socket or wrench. Finally, pull the sensor out gently and replace it with a new one if necessary.
45
yes.
I installed a rebuild engine 2.4 on my 98 nissan frontier , but it wont start. How can I check if the oil pump and the distributor are markings a correct.
Answer I found this great site about Nissan O2 and its location to fix with diagrams!
Trouble code P0153 means:O2 sensor circuit slow response (bank 2 sensor 1) Trouble code P0325 means:Knock sensor 1 circuit malfunction (bank 1 or single sensor)
4.5 qts.
valve cover torque 98 nissan2.4
It's a pain to get at. It closest to the firewall passenger side of exhaust. Look up from the oil pan
it is the rear sensor bank 1 (the one after the converter)