answersLogoWhite

0

The map sensor (Manifold Absolute Pressure sensor) in a Toyota Land Cruiser is typically located on the intake manifold. It is mounted on or near the throttle body to measure the pressure within the intake manifold, which helps the engine control unit (ECU) determine the correct air-fuel mixture for optimal engine performance. If you're troubleshooting, it's often near the rear of the engine, but the exact location may vary depending on the specific model year. Always consult the vehicle's service manual for precise details.

User Avatar

AnswerBot

6mo ago

What else can I help you with?

Related Questions

Where is automatic transmission oil temperature sensor located on a 1992 Toyota land cruiser?

The automatic transmission oil temperature sensor on a 1992 Toyota Land Cruiser is in the engine compartment. it is near the inlet/outlet tubes.


Which car is larger sequoia or land cruiser?

Land cruiser


Where is the cold start sensor time switch on 1989 Toyota land cruiser?

The cold start sensor is the top sensor on the right side of the thermostat housing as you are looking at the engine from the front of the vehicle. It is 22mm.


When was Toyota Land Cruiser created?

Toyota Land Cruiser was created in 1954.


What does diagnostic code PO135 mean on a 2001 Toyota Land Cruiser?

Diagnostic code P0135 on a 2001 Toyota Land Cruiser indicates a malfunction in the oxygen sensor circuit for the upstream (pre-catalytic converter) oxygen sensor. This code typically means that the sensor is not providing the expected voltage signal to the engine control module (ECM), which can result from a faulty sensor, wiring issues, or poor connections. Addressing this code usually involves inspecting the oxygen sensor and its wiring, and replacing the sensor if necessary.


Does a 2000 Durango have a MAF sensor or a MAP sensor?

It uses a MAP sensor.It uses a MAP sensor.


02 sensor locations 95 landcruiser 80ser 4.5lt?

The 1995 Land Cruiser 4.5 liter engine O2 sensor is located on the air cleaner housing. The O2 sensor will be attached to the back of the air cleaner housing.


Where is oxygen sensor for 97 Land-cruiser?

The oxygen sensor is located just upstream from the catalytic converter. Crawl under the vehicle, and locate the catalytic converter, after the exhaust manifold and before the muffler. There should be a four wire sensor there.


What automaker offers the Land Cruiser model?

The Land Cruiser is made by Toyota. The Land Cruiser has been made by Toyota since the 1950's and is one of their SUV offerings.


What is the correct psi for a 1994 Toyota Land Cruiser?

what is the correct psi for a 1994 land cruiser?


Where is the ecm on a 1996 Toyota land cruiser?

location of the ecm on the Toyota land cruiser 93


Where is the cabin filter for 2001 Land Cruiser?

how to change ac filter for land cruiser 2001