The oxygen sensors are in the exhaust one either side of the catalytic converter(s).
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
where is the oxygen sensor in a 2004 astro van
Change it
4
It is located before the Calaytic converter
The oxygen sensor on a 2004 Volkswagen Jetta is located in the engine area. It is usually encouraged to warm up the engine so as to ease the threads.
Bank 2 Sensor 2 is passanger side after cat.
In a 2004 Pontiac Sunfire, there are two oxygen sensors. One would be located in the exhaust before the catalytic converter. The other is located in the exhaust after the catalytic converter.
That is the pre - cat 02 oxygen sensor.
The Bank 2 Sensor 2 Oxygen Sensor on a 2004 Nissan Titan can be found on the exhaust manifold of the passenger side of the engine. It is located between the catalytic converter and the exhaust manifold. It is also known as a downstream or post-catalyst oxygen sensor.It is located between the catalytic converter and the exhaust manifold.It is on the passenger side of the engine.It is also known as a downstream or post-catalytic oxygen sensor.
On a 2004 Mitsubishi Galant with a 3.8L engine, the O2 sensors are typically located in the exhaust system. There are usually two sensors: one upstream (pre-catalytic converter) and one downstream (post-catalytic converter). The upstream sensor is located near the engine, while the downstream sensor is found further along the exhaust system, closer to the catalytic converter. For precise location, it's best to consult the vehicle's service manual or a repair guide.
On a 2004 Mitsubishi Galant, the O2 sensor bank 2 sensor 1 is located on the exhaust system. Specifically, it is positioned before the catalytic converter on the bank 2 side of the engine, which corresponds to the rear bank of cylinders. To access it, you may need to lift the vehicle for better visibility and reach. Always ensure the engine is cool before attempting to work on exhaust components.