In the 1992 Isuzu Rodeo, the solenoid is typically located on the starter motor, which is found near the bottom of the engine, often near the transmission. It may be attached directly to the starter or mounted on the engine block. To access it, you may need to lift the vehicle and remove any protective covers or components obstructing the view. Always ensure the battery is disconnected before attempting to work on electrical components.
There is none.
In recent experience, I have learned that a 1992 rodeo does not have a cut off switch and that on most the fuel pump is in the tank!
You can find the diagram for a 1992 Isuzu rodeo at the Isuzu website. There are options available to purchase a factory-direct Do-It-Yourself kit, with the diagram.
90 grade
Chain.
I don't think that will work unless you change over to rear disc brakes, the hub should not match.
probably a stretched out tv/kickdown cable
The fuel pump reset switch on a 1992 Isuzu Rodeo is typically located in the passenger compartment, near the right side of the center console or under the dashboard. It may be found near the kick panel or behind the glove compartment. If you’re having difficulty locating it, consult the vehicle's owner manual for specific details regarding its position.
Trannythese Isuzu transmissions take dextron III with mercron
well u have 2 blah blah,.mml;jhnj
Starter is on passenger side of motor underneath intake bolted to trans bellhousing.
It's right next to the hood release on the left hand side. It says 'Fuse' on it.