0
The expansion valve is located under the dash. It is within the plasitc housing (box shaped) with the condensor coil. The plastic housing can be removed after taking out the glove box, metal cross bar, and disconnectng the wire harness that runs across the plastic housing.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change the expansion valve on a 2001 Honda Civic?
How do you change the ac expansion valve on a 2001 Honda civic
Where is the IAC valve located on a 1999 Honda Civic LX?
where is the iac valve on a 99 honda civic lx?
How do you get to an expansion valve on a '98 Honda Civic?
Take it to an a/c man. He has the knowledge and tools to do it.
Where is the expansion valve on a 98 Honda Accord?
The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.
Where is the expansion valve 0n a1996 Honda civic?
Inside the evaporator case which is behind the glovebox
Where is the air conditioning expansion valve on 1990 Honda civic 1.5?
The expansion valve is inside the plastic box along with the evaporator core underneath the dashboard, right side.
Where is the thermostat bleed valve located on a 1997 Honda Civic?
There isn't one.
Where is the PCV valve on a 2004 Honda Civic?
The PCV valve of a Honda Civic is usually located on the upper right corner of the intake manifold. The position can vary, but this is typical of any automobile.
How do you adjust the idle on a 1985 Honda Civic?
Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.
Where is the PVC valve on a 2002 Honda Civic EX?
Where is the PVC valve on a 2002 Honda Civic EX?
Where is the PVC valve located on a 1983 Honda Civic sedan and how do you replace it?
The 1983 civic, hatchback with 1.5 engine does not have one.
Where is the AC Receiver Drier loction on a 1995 Honda civic?
The AC receiver drier on a 1995 Honda Civic is on the high-pressure side of the system. It is between the expansion valve inlet and condenser outlet.
