on the side of the motor the left side halfway down towards the firewall there is an electrical connector plugged into it disconnect the battery first then disconnect the plug then use an open ended wrench 19mm i believe thats the one and unscrew it but you should drain the antifreeze first then refill it with new antifreeze
Under the Distrubutor housing, 2 wire prong.
How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L
Can your pully holding alternater belt and ect. coming loose and belts coming off cause my Honda to jump timing ?
attached to the bottom hose ...kind of hard to get to,because its behind the two ECT censors...just two 10mm bolts
In a 2006 Acura TSX, the ECT (Engine Coolant Temperature) sensor is located on the engine block, typically near the thermostat housing. To access it, you may need to remove some components for better visibility. It is usually a cylindrical sensor with a wiring connector attached. Be sure to disconnect the battery before attempting any repairs.
On most D-series motors such as the 1.6L D16a1 and D16Z6, or the 1.5L D16b7 ect. the TDC sensor is in the Distributor and will probably need to be replaced as a unit.
ect sensor 1996 nissan pathfinder location?>
It would depend on what you mean by 'jerks.' It could be a fuel issue, tire alignment, ect. If it's really bad, it's probably best to take it in.
Trouble code P0128 means: ECT Sensor Below Thermostat Regulating Temperature
IAT= intake are temperature sensor ECT= engine coolant temp. sensor
location of engine cooling fan sensor
The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.