it is located on the engine (passenger side) in the back part of it you will see it if you take the oil filter and the idle valve it is attached to a little hose
pcv valve on nissan altima 2005
I had the same question. Seems it does not have a PCV valve.
YES
There isn't one.
== Answer The PCV valve on a 1993 Nissan Altima is located under the intake manifold just above the oil filter. You have easier access if the oil filter is removed. Not so easy...
the pcv valve on altima 98 it is located on the passenger side, right next to the idle valve u have to take the oil filter out, the idle valve, but still difficult to acces it takes at least 3 hours that's how long i spent doing it
AnswerIt doesn't have a PCV valve.Actually it does. The PCV valve for a 1993 Nissan Altima is located behind the engine below the intake. Buy a Haynes manual, the PCV is VERY tough to get too but it can be done. You can only get two bolts from the top but have to go from underneath the car to detach the hose.
I was looking for an answer to this question myself, and found it answered at: talkaboutautos.com
the pcv valve on most cars is usually located on the valve cover, and usually has a plastic or rubber hose that leads to your air intake hose. hope that helps
AnswerThere isn't one. On the top of the head in the rear, there is a tube that runs to the breather. That is the straight ventilation. No PCV needed.
replace only when u get a check engine light. the valve is good for the life of the motor(should be)
Contacted the dealer and the 02 does not have an egr valve The original question was "where is the PCV valve located? An EGR stands for "exhaust gas recirculation" which is different from a PCV valve "positive crank case ventilation". Each serves a unique and different function within the engine. Therefore the original question remains unanswered! daaaaa... The PCV valve is located on the back side of the valve cover. You will see the hose that the valve is connected to, running out from the back of the valve cover. The actual PCV valve is screwed into the valve cover, and the hose will have to be disconnected to access the valve.