It's by the break switch to the left of the break pedal.
The brake master cylinder on a 1985 Nissan 300ZX is located on the driver's side of the engine bay, mounted on the firewall. It is typically found near the back of the engine compartment, close to the brake booster. The master cylinder is connected to the brake lines and is responsible for supplying hydraulic pressure to the braking system.
On the drivers side of the engine compartment. Between the back side of the plastic intake hose and the brake master cylinder.
On a 1994 Nissan 300ZX, the Anti-lock Brake System (ABS) unit is typically located in the engine bay, mounted on the driver’s side near the brake master cylinder. The ABS module is a rectangular metal box connected to several brake lines and wiring harnesses. It’s important to ensure that any maintenance or repairs to the ABS system are conducted with care, as it plays a crucial role in vehicle safety.
remove the pedal arm pin so that you can freely move the pedal and have an access to the rubber stopper slots.
Master Cylinder for brake and clutch are located next to the ABS unit on the firewall of the driver side in the engine bay. Slave cylinder for clutch is located on the bottom of the transmission.
Do you have power to the connection that is on the back of the center brake light? the red wire should have voltage to it. If not, it may be grounding out somewhere.
To remove the brake light switch on a 1996 Nissan 300ZX, first disconnect the negative battery terminal to prevent any electrical issues. Locate the brake light switch, which is typically found near the top of the brake pedal assembly. Unscrew the switch from its mounting position and disconnect the wiring harness. Finally, remove the switch from the bracket, and you can replace it with a new one if needed.
on the brake pedal
The brake light switch on a Nissan is located just behind the brake pedal. It sends a signal to the brake lights when the pedal is pressed to turn them on.
The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.
theres one under the hood near the brake booster silver can with two lines running through it.
Under the hood at the top right corner. The brake master cylinder is also there, but the clutch is the smaller of the two.