The brake switch on a 1999 Corolla should be on the top of the brake pedal arm. If the switch goes bad, then the brake lights might stay on, or not come on at all.
How do I get engine codes for 1999 toyota corolla?
You have 2 problems. one is the license light bulb is burned out and the stop light switch is bad. Check them out. GoodluckJoe
Check that the switch that moves from cool to hot (Is like a sliding switch on a 1990 Corolla I think) is actually opening the vent that controls flow of hot air
30 PS is the correct tire pressure for a 1999 Toyota Corolla.
where is coolant tempreture senser in 1999 corolla
To change the brake light switch on a 1999 Toyota Avalon, first, disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is usually mounted near the top of the brake pedal assembly. Unplug the electrical connector and remove the switch by turning it counterclockwise. Install the new switch by reversing these steps, ensuring it is properly adjusted to activate when the brake pedal is pressed.
A battery may get hot on a 1999 Toyota Corolla when it is being used for a long period of time.
TROUBLESHOTING FOR REPLACED STARTER IN TOYOTA COROLLA 1999.
in USA
I discovered that when I start my car (1999 Toyota Corolla CE) with the emergency brake engaged the head lights don't come on. They come on as soon as its released and they wont go off if you reset the break. Only when the car is turned on with the break set.
The 1999 Toyota Corolla takes 20" driver side and 18" passenger side wiper blades.
the 1999 Toyota corolla does not use a maf but it uses a MAP sensor located somewhere around the intke manifold