I assume that you are referring to the ECM or ElectronicControl Module. It is located on the passenger's side floor (for left-hand control vehicles) under the carpeting.
Will fit Legacy/Outback Model Year 1995 to 1999.
how to replace high/low beam, turn signal lever on 1996 subaru outback wagon
There is no such thing as a 1995 subaru outback, the outback package was not offered on a subaru legacy until 1996, you either have a 1996 subaru outback, or you have a 1995 subaru Legacy L or LSI wagon. Both will be covered in most guide books you can pick up at your local autoparts store.
The Engine Control Module (ECM) for a 1996 Subaru Legacy Outback is typically located in the passenger compartment, specifically under the dashboard, near the driver's side. You may need to remove some trim panels to access it. It is usually mounted on the firewall or the side of the center console. Always ensure to disconnect the battery before attempting to access or replace the ECM.
Two.
yes
A 1996 Subaru Legacy Outback requires: For automatictransmission: DEXRON III For manual transmission: GL5 75W90 gear oil
Should fit second generation Legacy/Outback model year 1995 to 1999.....
Check out http://www.fueleconomy.gov/feg/sbs.htm
Take them out then put the new ones in
Directly below the alternator on the block.
Probably 1996 thru 1999 if it is going wagon to wagon.