On my '91 it's below the thermostat.
The coolant temperature sensor on a 2001 Toyota RAV4 is located on the exhaust manifold. It is on the driver's side of the manifold.
The 2006 Toyota coolant temperature sensor is located on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
Somewhere under the hood!
It depends on which of them. The one for coolant is located in the water inlet. Ambient temperature sensor is located in the filter box.
The 2003 Toyota Camry coolant temperature sensor can be found on top of the engine. The coolant temperature sensor will be near the center of the exhaust manifold.
I've been having the same problem, did you find the location yet?
the sensor is right next to a radiator cap at the bottom of the neck.
where is coolant tempreture senser in 1999 corolla
The coolant temperature sensor, which is located behind the engine block near the firewall, senses when the coolant temperature reaches a predetermined temperature so that the transmission can shift into overdrive. This sensor and the hose preceding it can get gunked up with cystallization from the coolant (red Toyota coolant is notorious for doing this) and can prevent proper flow to the sensor i.e. your transmission may take longer to shift into overdrive or may not shift at all depending on how constricted the hose is.
In the Toyota Avanza, the coolant temperature sender is typically located near the engine block, often on the thermostat housing or cylinder head. It is positioned in a way that allows it to accurately measure the temperature of the coolant. To access it, you may need to remove some components or covers, depending on the specific model year and engine configuration. Always refer to the vehicle's service manual for precise location and removal instructions.
Well, honey, the coolant temperature sensor on a 1995 Toyota Tercel is usually located near the thermostat housing or on the cylinder head. To replace it, first, make sure the engine is cool, then disconnect the electrical connector, unscrew the sensor using a wrench, apply some thread sealant on the new sensor, and install it in the same location. Don't forget to reconnect the electrical connector and refill the coolant if needed. Good luck, darling!
Ignition - Coolant Temperature Sensor