answersLogoWhite

0

It stands for Engine Coolant Temperature. I believe it is wired up to your hot/cold gauge in the dashboard of the vehicle. It screws into the side of the engine and monitors the temp of your radiator fluid as it circulates.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the code po118 on a Mazda mpv?

The code PO118 on a Mazda MPV indicates a problem with the engine coolant temperature sensor (ECT). This code typically means that the sensor is reading a temperature that is higher or lower than expected, which can affect engine performance and fuel efficiency. It may be caused by a faulty sensor, wiring issues, or problems with the engine's cooling system. It's advisable to diagnose the issue further and potentially replace the sensor if needed.


Where is the IAT sensor on a 2000 Mazda mpv?

The 2000 Mazda IAT sensor can be found on the back of the engine. The IAT sensor will be just above the bell housing.


Where is oxygen sensor bank 1 sensor 2 on a 2000 Mazda MPV?

That should be the sensor after the catalytic converter.


Bank 1 sensor 3 oxygen sensor location on Mazda mpv 2001?

That would be the sensor after the catalytic converter.


When was Mazda MPV created?

Mazda MPV was created in 1989.


How do you change an oxygen sensor on a Mazda mpv?

how you know with each one is with each one wen you reconnect everything .


Will the 3.0L Mazda MPV fit in a 2002 Mazda 626?

Can a Mazda 626 engine fit in a Mazda MPV mini van?


Where is the motor mount on a Mazda MPV?

how many motor mount has a mazda mpv 2000


Where is thermostat located in 2001 Mazda mpv?

Where is the thermostat located in a 2001 Mazda mpv


Has a Mazda mpv 2000 a timing belt or chain?

The Mazda Mpv 2000 timing chain


How do you change a o2 sensor on a mazda mpv?

To change the O2 sensor on a Mazda MPV, first, ensure the engine is off and cool. Disconnect the negative battery terminal for safety, then locate the O2 sensor, usually found on the exhaust pipe or manifold. Use a wrench or O2 sensor socket to unscrew the old sensor, then install the new sensor by threading it in and tightening it securely. Reconnect the battery terminal and start the engine to check for any warning lights.


What is the cost to replace the head gasket on a Mazda MPV?

What is the cost to replace the head gasket on a Mazda MPV?