Behind the luggage compartment
The term "spyder" comes from the frame structure of the convertible top. The MR2 was made from 1984 to 1999 in hard top or T-Top form. The MR-S, aka the MR-Spyder or MR2 Spyder was the convertible form of the MR2 made from 2000 to 2007. It was the third generation of this car.
To clear the ECU memory bank on a 2003 Toyota MR2 Spyder, you can disconnect the negative battery terminal and leave it off for about 10-15 minutes. This will reset the ECU and clear any stored trouble codes. After reconnecting the battery, you may need to drive the car for a short distance to allow the ECU to relearn the optimal settings. Always make sure to take precautions when working with the vehicle's electrical system.
It has a chain. For info on Spyder create an account at spyderchat.com...it's the cheese wiz to your ritz cracker.
I have a 2002 MR2 Spyder. The tail light relay is behind the fuses box on the left side of dash S H
The radiator is still located in the front like any other car, it just has extended piping to reach the radiator. If you ever take a look at a technical diagrahm of the Spyder, you'll see its still located in the front and the piping runs on each side of the car.
in the fuel tank
after about 80k
In the MR2 MK2, the ECU (Engine Control Unit) is typically located behind the passenger side dashboard. To access it, you'll need to remove the lower kick panel and possibly the upper dash panel. The ECU is housed in a metal casing, making it a bit challenging to reach, but it's essential for managing the engine's performance and diagnostics.
The Toyota MR2 Spyder was first launched in 1976. It is a two-seat sports car manufactured by the company of Toyota. They are produced in Japan. There are three generations of the car.
On a 2003 Toyota MR2 Spyder, the starter is located on the driver's side of the engine bay, near the rear of the vehicle. Specifically, it is mounted to the transmission bellhousing, making it somewhat accessible from underneath the car. To reach it, you may need to remove some components or panels for better access.
About 4-6 pounds.