answersLogoWhite

0

behind the glove box under the dash 3 screws hold it in

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you fix a blower fan that only works on high I have a 2002 Chevy Impala?

You need to replace the resistor board locate on the inside passanger side where the blower motor is located . It is attached to the blower motor with 4 screws as I recall and can be readily replace if you are somewhat handy around cars. The part Iam sure must be purchased at the dealer for around 35 dollars.


Cost of heater fan for 2002 Ford Taurus?

Blower motors cost anywhere from $35-70. See "Related Questions" below for more


What is the electronic sensor located on the bottom of the radiator of a 1986 Mazda B2000 with a 5 Speed Tran?

It is a Radiator Fan Switch - You can purchase it at Advanced Auto for about $35 but they have to order it It is a Radiator Fan Switch - You can purchase it at Advanced Auto for about $35 but they have to order it It is a Radiator Fan Switch - You can purchase it at Advanced Auto for about $35 but they have to order it


What is the Battery size for 2004 Acura TL?

35


What is the rear leg room of the 2001 Acura TL?

The 2001 Acura TL has 35 in. of rear leg room.


What is the rear leg room of the 2003 Acura TL?

The 2003 Acura TL has 35 in. of rear leg room.


What is the rear leg room of the 2002 Acura TL?

The 2002 Acura TL has 35 in. of rear leg room.


What makes the ac blow on only a few of the numbers and then quit blowing altogether?

Well if it is your fan regardless of ac or not it would probably be the blower motor resistor. I had the same problem the part fixed everything it is about $35 for the part if you are able to do it yourself.


How do you find where blower motor resister is located on 2003 trailblazer?

The blower motor resistor is located behind the glove box up under the dash. If you remove the the lower panel under the glove box (4 screw nuts) you can look up and see the wires going to it from the blower motor. You must remove the plug from the blower motor so it is easiest to drop the glove box down and out of the way by pushing the stopper to the side and letting it drop down on its' hinge. This reveals the connector to the blower motor. Then remove the 2 screw nuts on the resistor and then replace it. Very easy and parts are reasonable ($35 from www.parts4chevys.com)


TP-35 How many minutes should a blower be operated before starting an engine?

4


What is the EPA city and highway mileage estimate for the 2014 Acura ILX?

The EPA mileage estimate for the 2014 Acura ILX is 24 mpg in the city, 35 mpg on the highway.


What is the EPA city and highway mileage estimate for the 2013 Acura ILX?

The EPA mileage estimate for the 2013 Acura ILX is 24 mpg in the city, 35 mpg on the highway.