0
What else can I help you with?
How do you remove fuel pump on Nissan pulsar n13 1990?
To remove the fuel pump on a 1990 Nissan Pulsar N13, first disconnect the negative battery terminal to ensure safety. Next, access the fuel pump by removing the rear seat or the access panel in the trunk, depending on the model. Disconnect the fuel lines and electrical connector from the pump, then unbolt the pump assembly and carefully lift it out. Finally, replace the pump and reassemble everything in reverse order.
How do you tighten the cam belt on pulsar n13?
With the water pump
Do have to squeeze the oil out of the tappet lifters when replacing the head on a pulsar N13 1.8le motor?
you might try to run diesel fuel insted of oil for about 1 minute.
What is the firing order of a 1991 Nissan Pulsar n13?
1 3 4 2
Is there a turbo kit for N13 pulsar Q 89mod 1.8?
No.. custom job.. other hand drop in a ca18det.. :D
Where is the oil filter on a Nissan Pulsar N13?
Above the CV joint towards the back of the engine on the left hand side (as you look at the car).
How do you remove the headlight on a 1991 Nissan Pulsar N13 Vector sedan?
To remove the headlight on a 1991 Nissan Pulsar N13 Vector sedan, start by opening the hood and locating the headlight assembly. Disconnect the electrical connector and then remove the screws or bolts that secure the headlight assembly in place. Carefully pull the headlight out of the housing, taking care not to damage any clips or wiring. Finally, replace or reinstall the new headlight by reversing the steps.
Can you put a turbo in a 1987 holden camira?
Yes of course. Look up the forums on how to install a turbo kit on a Nissan N13 Pulsar, which uses the same basic GM engine.
1989 pulsar n13 1.6 wont start as there is no spark Done all the tests and put in a new coil but still no spark on plugs or HT lead from coil?
check the connection to the coil to the battery and check your distributor
What is the torque settings for head bolts of a Nissan Pulsar N13 1.5 ltr?
The torque settings for the head bolts of a Nissan Pulsar N13 with a 1.5-liter engine typically range from 20 to 25 ft-lbs (27 to 34 Nm) for the initial torque and then around 50 to 60 ft-lbs (68 to 81 Nm) for the final torque. It's important to follow the correct tightening sequence and procedure to ensure proper sealing and prevent warping. Always refer to the vehicle's service manual for the most accurate specifications and procedures.
Where is the N13 Dental Clinic located?
The N13 Dental Clinic is located at 138 Bowes Rd, London, Greater London, N13 4NP, in the United Kindom. You can obtain this address by visiting their official website, or via their pamphlets given out to customers.
What is NH N 13 pay grade?
n13 paygrade
