Passenger side on floor above floor mat. there will be a button to push, push it and that should reset t.
Mazda truck b3000 where is the fuel pump reset switch located
Gmc does not use inertia/reset switches.
Look in the kick panels The fuel pump or the "inertia switch" is located behind the glove box in 1994 and earlier models, in 1995 and newer, it is located behind the passenger side kick panel. In the B-series (Mazda?) it is located on the passenger side transmission "hump", under the carpeting. The reset button is located on top of the switch and just needs to be pressed to reset.
It should be located in the trunk on the drivers/passengers side.
The 2001 Ford Ranger owners manual shows it as being in the right front passenger footwell by the kick panel
Was wondering the same.. for a Fuel injected 1987 Mazda 626 non-Turbo According to a Mazda dealer I just called. There is no reset switch. The Fuel pump is located in the gas tank. and the Pump Relay is on the firewall of the passenger side. Regards, Yanek What do you want to reset? "Check Engine" codes can be reset by disconnecting the battery for 5-10 minutes.
Gm vehicles do not use inertia/reset switches.
There is not a reset switch.
On a 1996 Ford Ranger ( ASSUMING it is the same setup on your 1996 Mazda b3000 ) the fuel pump shut off switch ( inertia switch with the reset button on top ) is located in the front passenger footwell , in the corner , above the carpet and below the dash
There is none.
Yes, a 1995 Mazda MPV does have a fuel reset switch, often referred to as a fuel pump inertia switch. It is typically located in the passenger compartment, either under the dashboard near the driver's side or in the center console area. If you can't find it, consult the owner's manual for the exact location.
In order to reset a tripped fuel cut off switch you depress the red button located on the top of the switch. To locate the switch depends entirely on the year and make. Most likely its in the trunk area or in the right front kickpanel area.