0
What else can I help you with?
Where is the fuel filter located on a 1990 Mitsubishi Mighty Max pickup truck?
Should be right next to the fuel tank underneath the truck bed.
Where is the starter located on a 1994 Mitsubishi Mighty Max pickup truck?
Get under your truck, the starter is going to be where the bellhousing of the tranny meets the motor. you'll see where it is as there will be an irregularity in the bell housing.
Firing order on a 1988 Mitsubishi mighty max truck 2.6?
1432
How do you replace the drive belt on a 1991 Mitsubishi mighty max truck?
Need a diagram to set the timing Mitsubishi 1991 pu
Why is my 91 Mitsubishi mighty max truck not firing but motor turns?
Could be ignition module
Where is the heater box located on a 2004 Dodge truck?
The heater box is under the dash.
Where is the oil pump on a Mitsubishi mighty max truck?
The oil pump is not located in the comon location which is above the oil pump. Its located behind the water pump and timing chain cover. Probably the most expensive time consuming place to put it.
How do you fix a stuck tailgate on a 1988 Mitsubishi Mighty Max pickup truck?
when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections
Where is the heater system located on a 1995 Chevy truck?
It is located behind the glove box
Where is located block heater plug 4300 international truck?
The block heater plug on a 4300 International truck is located just behind the battery. A heavy duty outdoor cord will be necessary to plug the block heater into an electrical outlet.
Where is the data link connector located on a 1988 Mitsubishi pickup truck?
The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.
Why does your 1991 Mitsubishi Mighty Max 2.4 truck start up then die right away?
my 87 just had this problem...it was the mass air flow sensor. if its not that try the computer my 86 had the same problem, it was the Mass Air Flow Sensor
