answersLogoWhite

0

Sorry. Not familiar with an "iac" valve. Could you please spell it out completely without abbreviating it?

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the IAC valve located on a 1999 Honda Civic LX?

where is the iac valve on a 99 honda civic lx?


Where is the IAC Valve located on 2004 dodge 5.7 hemi?

Where is the iac valve located on 2004 dodge 5.7hemi


Where is the iac valve on a 97 Camry?

The IAC is located on the throttle body.


How do i replace the iac valve for 2000 impala?

The IAC is located on the throttle body. Simply unplug the dirty IAC and clean or replace the IAC.


Where is the iac valve located on a 1998 Mercury Mystique?

were is the iac locate on a 1999 mercury mystique


Where is IAC valve located on 92 olds achieva?

The 1992 Oldsmobile IAC valve can be found attached to the firewall in the engine compartment. The valve will be on the passenger side of the firewall.


How do you clean the IAC valve on a 1999 Honda CR-V?

The Haynes Manual (copyrighted) gives no instructions for the cleaning of the IAC, only its replacement if defective.


Why do Honda engines idle up down but doesn't when its in drive?

its the iac valve or maf sensor


Where is the ICA located on a 2003 Dodge Durango?

The IAC valve is located in the intake manifold


Where is the IAC valve in the 2000 Honda Accord V6?

It's under the throttle body. To get to it, you'll need to remove the throttle body and flip it upside down. The IAC valve is mounted by two screws to the throttle body, and it has a gasket that you will need to replace if you remove the IAC valve, so make sure you have a new gasket on hand if you intend to take off the IAC valve.


Where is the iac valve located on 2001 Toyota Tundra 4.7L?

There is no IAC Valve on the Tundra V8s. The ECU controls the idle speed via the Throttle Position Sensor.


Where is the iac valve located on a 1989 Chevy suburban?

The IAC is located on the passenger side of the throttle body toward the rear. It screws into the housing using a 1" wrench.