mounted on the metal intake near the firewall. should be two large hoses. one from the the rubber intake to the ICV (idle control valve) and one from the ICV to the metal intake. hope this helps
The Idle Speed Control actuator is located right behind the air intake plenum
check for vacum leak
On idle speed control actuator is located on the front of the air intake plenum
its probably your TPS Switch or your idle control sensor, check engine light will not come on for either take to Hyundai dealership
The Idle Air Control (IAC) valve on a 2001 Hyundai Elantra is typically located on the throttle body, which is situated on the intake manifold. It is usually mounted to the side of the throttle body and connected to the intake air stream. To access it, you may need to remove the air intake duct and other components that obstruct the view. Always refer to a repair manual for specific instructions related to your vehicle model.
idle air control motor where is it located
where is the idle control motor for a 1998 ford escort
On a 1995 Hyundai Elantra, the idle control valve is typically located on the throttle body. It's connected to the air intake system and is responsible for regulating the engine's idle speed. To access it, you may need to remove the air intake hose or other components that obstruct the view. Always refer to a repair manual for specific instructions and diagrams.
The idle is control by the idle air control motor from outputs from the Engine Control Module.
a bad idle sensor control valve to start with or your egr valve has a vaccum leak
it seems there a small screw back of the intake but the idle is control by the ecu.
The idle is adjusted by way of the Idle Air Control motor as directed from the Engine Control Module. The idle is computer controlled. I changeTHE IAC motor for a new one ,still there is a bit of a rough Idle, what can be the trouble