In a 1994 Honda Del Sol, the map sensor is typically located on the intake manifold. It is mounted near the throttle body, often on the driver's side of the engine bay. You can usually find it attached to a bracket or directly to the manifold itself, connected by a vacuum hose and an electrical connector.
How is the wire of o2 sensors in a honda del sol 1993?
inside the ecu
The horn relay on a 1994 Honda Del Sol is located in the engine compartment. It will be behind the fuse box.
No, a 1994 Honda Del Sol does not have an OBD-II sensor; it is equipped with an OBD-I system. OBD-II became standard in vehicles starting in 1996. If you need to diagnose issues with a 1994 Del Sol, you would use an OBD-I scanner or the manufacturer's specific diagnostic procedures.
Only the 1996 and newer Honda's have a i.a.t sensor. It is located in the air intake tube that runs to the throttle body/intake manifold.
it is located above the transmission. there is one wire that goes into it.
the oil dipstick is located between the exhaust manifold
In the engine compartment about the middle towards the windsheild.
The map sensor is located on top of your throttle body. If u have stock or after market intake that is connected to the throttle body right on top of the throttle body there is a black sensor and it will say map sensor Hope this helped
On a 1993 Honda Del Sol, the crankshaft position sensor is typically located near the crankshaft pulley, on the engine block. It is mounted on the transmission bell housing, close to the flywheel. To access it, you may need to remove some components for better visibility and space. Always refer to a repair manual for specific details and procedures.
m18x1.5 is the threading for Honda civic/del sols, and probably most other o2 sensor bungs
Yes, as the dash and wiring are identical for these model years.