answersLogoWhite

0

O2 sensors measure O2 levels in the exhaust so they are in the exhaust pipes. On newer vehicles there is 1 before the catylitic converter and another after to monitor the function of the converter. Pre obd2 vehicles usually have 1 sensor between the engine and the catylitic converter.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is bank 1 O2 sensor located on a 1997 Mazda MPV?

It is located posterior of the flux-capacitor, to the left of the y-pipe's s bend.


Where is the thermostat located on a 1997 Mazda MPV?

The thermostat on a 1997 Mazda MPV is located on top of the engine, under the upper radiator hose. It controls the flow of coolant through the vehicle.


Where is thermostat located in 2001 Mazda mpv?

Where is the thermostat located in a 2001 Mazda mpv


How many oxygen sensors are on a 1997 Mazda mpv?

how many oxygen sensors are on a 1997 Mazda mpv lx


Where is the starter solenoid located on a 1997 Mazda mpv?

the solenoid is on the starter. It's the part the wires go into.


1997 Mazda mpv wont start battery is good?

1997 Mazda MPV's SUCK A**! Do your self a favor and save yourself a lot of headaches and get rid of the turd!


Where is Transmission range sensor on 2001 Mazda mpv?

It is located on top of the transmission underneath the thermostat. Where the shifter linkage attaches to the transmission.


Where is oxygen sensor bank 1 sensor 2 on a 2000 Mazda MPV?

That should be the sensor after the catalytic converter.


Where is the IAT sensor on a 2000 Mazda mpv?

The 2000 Mazda IAT sensor can be found on the back of the engine. The IAT sensor will be just above the bell housing.


Where is the egr valve located on a 1990 Mazda mpv 6 cylinder?

There is no egr valve on a 1990 Mazda MPV 6 cylinder


Bank 1 sensor 3 oxygen sensor location on Mazda mpv 2001?

That would be the sensor after the catalytic converter.


Where is the starter located on 1997 Mazda MPV?

The starter on the 3.0 (4WD) is located low on the passenger side of the block. It is difficult to get at because the differential is also on that side. -RJC