answersLogoWhite

0

it doesn't have one

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Is the 1994 Mazda protege an obd-I?

Yes the 1994 Mazda Protege is a OBD 1 port


Where is the OBD II port on a 2002 Mazda Tribute?

The 2002 Mazda Tribute OBD 2 port is on rear edge of dash; right of hood release


What OBD Scanner applies to a 1991 Mazda RX7?

Only OBD-II cars use a scan tool that plugs into the OBD-II port. OBD-II did not come out until 1996. Furthurmore, to my knowledge, the 2nd generation rx7's didn't use any form of OBD.


2001 Mazda protoge obd II location?

The 2001 Mazda Protoge OBD 2 port is on rear left edge of dash; next to hood rise; faces down


Where is the Location of odb connector Mazda millenia 1999?

The 1999 Mazda Millenia OBD 2 port is on lower right corner of dash; next to tunnel


Where is the diagnostic port on a 1991 Geo Metro?

Left side bottom of dash, Is OBD-1.


Where is the OBD port located on a 2006 Mazda 3?

It's the small little "nook" above the lever that you pull to pop the hood.


Where is the obd port on a 1993 Plymouth duster?

The obd 1 port is next to the battery


Where do you find obd port on a 1988 s10?

good luck! There is no OBD port on a vehicle that old


Where is the obd port on a 2008 Jeep Patriot?

The OBD port is under the dash on the driver side.


Is th 1995 Mazda Protege an OBD-II?

Look for the OBD II connector under the driver's side dash. It was required 1996 and up but some models had the connector before it was necessary.Answer96 and up According to the Chilton's manual, the 1995 Protege and Millenia are OBD-II, also 1994-1995 Mazda 626 with ATX transmissions are OBD-II, and then all models 96 and up...I have a 95 buick with OBD II, however it requires a different plug to work with a scanner. If you take the car to Autozone or Advance Auto Parts to have them scan it and it won't scan it could be the same reason mine won't. In 95 they were transitioning to the (then new) OBD II system, and some of the first OBD II harnesses only had 5 pins rather than the full (I believe 10 pins) found on the 96 and later OBD II harnesses.


What OBD Scanner applies to a 2002 Mazda RX7?

obd 2