stand in front of your van, then left side undernearth, use plier filter wrench to remove the old filter. You can this this filter in kragen or autozone.
It's inside the Transmission oil pan. Wix Filter # 58888 Hope This Helps.
Fram CH9972
From my experience Toyota oil filter works great.
Yes, that filter fits a 2004 Toyota Sienna. But, I would not recommend a Fram filter. Purolator, Bosch, & Wix, all make superior filters to the Fram.
it fits a Toyota sienna with a 3.0 v-6
On a 2012 Toyota Sienna, the oil filter is located on the underside of the engine, towards the front, near the oil pan. It is typically accessible from beneath the vehicle. To reach it, you may need to lift the vehicle for better access. Make sure to have an oil catch pan ready when removing the filter to catch any spilled oil.
The owners manual states the capacity is 4.7 litres, including new oil filter.
The oil capacity of a 2009 Toyota Sienna is approximately 4.5 quarts (or about 4.3 liters) when using a standard oil filter. If using an oil filter with a larger capacity, the total may be around 5 quarts. Always refer to the owner's manual for the most accurate specifications and recommendations.
The oil filter on the 2006 Toyota Sienna is in the front, pointing toward the front under the exhaust manifold. As you look under the hood from the front, it is in the center directly under the exhaust manifold.
It should. It looks like it's compatible with the 98 - 03 Sienna.
Bone dry with filter change, 6.4 US qts.
Nevermind. Finally found it wedged up in the front behind the radiator.