0
On the 1988 Pulsar NX SE, when you're standing in front of the car, looking into the engine compartment, it's on the left side (the passenger side) near the top of the engine, towards the back. Just follow the big hose from the top of the radiator to where it connects to the engine. It looks like it's held on with 3 bolts that are probably able to be removed using a normal socket set without removing anything major around it. I'm going to replace mine tomorrow...
What else can I help you with?
What cars takes H6054 seal beam?
Nissan Pulsar NX
How do you install an ignition module on a 1984 Nissan Pulsar NX?
its inside the distributor
Does the 1990 Nissan Pulsar have a timing belt or chain?
The 1.6 litre four cylinder engine in a 1990 Nissan Pulsar NX has a timing CHAIN
Where is the wire you plug your lighter wire into in the dash of an 1985 Nissan Pulsar NX?
In the dash
Where can you get a engine wiring harness for a 1988 Nissan Pulsar NX?
The best place is to get it from a wrecking yard.
Where is the starter on a 1987 Nissan Pulsar NX?
" The Pulsar starter is located centrally, underneath the engine close to the passenger compartment." According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.
Does the 1989 Nissan Pulsar have a timing chain or a timing belt?
In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT
When was the Nissan Pulsar EXA first produced?
The Nissan Pulsar EXA 2-door was produced in 1985. It featured sleek coupe styling with pop-up head lamps. The EXA was known as the NX in North America.
Where is the starter motor located on a Nissan nx coupe?
On the Nissan NX Coupe the starter is located to the right of the transaxle and to the left of the air cleaner. The air filter will need to be removed as well as the battery to access the starter motor.
What is the cylinder firing order for a 1988 Nissan Pulsar NX 1.6 L?
The cylinder firing order for a 1988 Nissan Pulsar NX with a 1.6 L engine is 1-3-4-2. This means that the cylinders fire in the sequence of cylinder 1, then 3, followed by 4, and finally 2. This firing order is typical for many inline-four engines, ensuring smooth operation and balance.
Where is a O2 sensor located on a 1992 Nissan NX?
It is in the exhaust pipe right after the exhaust manifold.
How do you fix a Nissan Pulsar NX that has overheated diagnostics?
First, if you haven't warped the head, try replacing the Thermostat and all the antifreeze to something new in this millineum. Second, make sure your radiator isn't leaking along with all of your collant hoses. If that doesn't take care of it, you should take it to a mechanic to get a checkup.
