The transfer box for the tail light on a 2005 Isuzu Ascender is typically located in the rear of the vehicle, near the tailgate area. You may need to remove the interior trim or access panel in the rear to reach it. Always refer to the vehicle's service manual for specific instructions and diagrams for your model.
where are the spak plugs located on the 2005 ascender?
You turn it one notch from the off position
The cabin filter for the 2005 Isuzu Ascender is located behind the glove compartment. To access it, you typically need to remove the glove compartment by unscrewing or unclipping it. Once the glove compartment is out of the way, the cabin filter can be found in its housing, which can be easily pulled out for replacement.
Under the resonator box on the top of the motor. They are under the six individual coil packs.
To replace the switch in a 2005 Isuzu Ascender, first disconnect the battery to ensure safety. Remove the panel covering the switch by unscrewing any screws and gently prying it off. Disconnect the wiring harness from the old switch, then connect the new switch and reassemble the panel. Finally, reconnect the battery and test the new switch to ensure it functions correctly.
One is under the 1st row drivers side passanger seat in a blcak box and another is under the hood just above the battery in a latch locked box.
Bought one for my 2004 Isuzu Ascender. Depends on what filter you buy, and who replaces it. The cost for the actual filter ranges from $7 to $48 dollars for the 'professional' fuel filter. The labor ran me $50.00 to install it. I am sure I could have had it done cheaper, but am new to the area and haven't yet found a good, honest, reputable, non-franchise (independent) mechanic, if such a creature exists.
The 2005 Isuzu Ascender takes 22" drivers and 16" passenger side wiper blades. See sources and related links below for more information. Since there are currently over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
I believe the tie rods are sealed, not meant to be serviceable. Some after market parts do require regular lubrication, and this will be indicated by the presence of grease zerts. No zerts, no grease.
Fuel filter is located inside the fuel tank so you have to remove you fuel tank to replace the fuel filter. I had a problem with mine and had to replace the fuel pump and filter at the same time.
If you do NOT have the DIC package installed, you only need to turn the car to ON and slowly pump the accelerator five times. The oil life indicator will blink for a bit and go off for another 3-7.5k miles.
Fuel pump sending unit needs to be replaced in the Gas Tank. Big Fix by a Qualified technician. I believe you have to replace the whole fuel pump assembly unit.