if you stand on the driver side of the vehicle you should be able to see the master cylinder for the brake system and the fuse box right in front of you.look down in a directiond between the fuse box and the master cylinder for brake you'll see the short dip stick for transmission.make sure you have the vehicle at the operating temperature when checking the level of the fluid and make sure the vehicle is leveled even.
Yes, you can use the same transmission dipstick from a 1993 Acura Legend for a 1990 Acura Legend, as the two models share similar transmission designs and components. However, it’s always a good idea to verify part compatibility by checking the part numbers or consulting a mechanic to ensure proper fit and function.
on the engine
There is no dipstick on the standard transmission , the fluid level is checked at the fill plug on the transmission
Assuming you have a automatic transmission the dipstick should be located under the hood, behind the engine, on the passenger side.
I it is a manual transmission it has no dipstick. If it is A/T it is located on the front of the transmission near the engine block. It is very small and has no tube. Look carefully.
The transmission dipstick is located on the passenger side of the engine compartment, adjacent to the evaporator case.
In between the air filter and the raditior
You are going to need a long funnel as it goes into where you pull the dipstick for the transmission fluid out
rear passenger side of engine
If auto--through the dipstick tube If standard through side plug in transmission
It is located on the left side of the car facing the engine toward the back. Should be marked TRANSMISSION.
To add transmission fluid to a 1990 Nissan Pulsar with an automatic transmission, locate the transmission dipstick, which is usually found near the back of the engine bay. With the engine running and the transmission in park, pull the dipstick out, wipe it clean, then reinsert it to check the fluid level. If the fluid is low, remove the dipstick again and use a funnel to add the appropriate type of transmission fluid through the dipstick tube, being careful not to overfill. Always check the owner’s manual for specific fluid requirements and capacity.