answersLogoWhite

0

not exactly sure for your year but there should be one near the firewall toward the middle it should have a yellow loop it its missing then there will be a black tube sticking out look near the egr valve in the back of the engine.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Will Chevy 400 small block bolt up to 1990 300zx transmission?

A Nissan 300ZX? No


Where is the starter on a 1990 Nissan 300zx?

On the underside, passenger side, of the transmission.


Where is the inhibitor switch on a 1990 Nissan 300zx?

it is located on the transmission itself


Where is the transmission dipstick located on a 1990 Nissan 300zx?

If you stand in front of the driver's side front wheel, looking into the engine bay, it is right in front of you, slightly below the engine cover


How do you put transmission fluid in 1990 Nissan 300zx?

To add transmission fluid to a 1990 Nissan 300ZX, first, ensure the vehicle is on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine bay, and remove it to check the fluid level. If it’s low, use a funnel to carefully add the appropriate type of transmission fluid through the dipstick tube until it reaches the recommended level. Always check the owner's manual for the correct fluid type and specifications.


Did 1990 Nissan 300zx's have airbags?

Yes.


What is the carrying capacity of a 1990 Nissan 300ZX?

The "1990 Nissan 300ZX" was a very popular model in it's time. The "Card ID" website noted the carrying capacity of the "300ZX" was noted to be a hefty 1500 pounds.


Where to add transmission fluid 1990 Nissan Pulsar automatic?

To add transmission fluid to a 1990 Nissan Pulsar with an automatic transmission, locate the transmission dipstick, which is usually found near the back of the engine bay. With the engine running and the transmission in park, pull the dipstick out, wipe it clean, then reinsert it to check the fluid level. If the fluid is low, remove the dipstick again and use a funnel to add the appropriate type of transmission fluid through the dipstick tube, being careful not to overfill. Always check the owner’s manual for specific fluid requirements and capacity.


What are the specs on a 1990 Nissan 300zx?

http://www.zshop.net.au/Z32tech.htm


Can you put a 350z engine and transmission in a 300zx?

Yes my car is a 1990 300zx with a 2008 350z motor and 6speed transmission


Where is the lockup solenoid on 1990 Nissan 300zx?

The lockup solenoid on a 1990 Nissan 300ZX is typically located within the transmission, specifically in the valve body. To access it, you may need to remove the transmission pan and filter. It's recommended to consult the service manual for detailed instructions and to ensure proper diagnostic procedures are followed if you're experiencing issues related to the lockup function.


What is the horse power on a 1990 Nissan 300zx non turbo?

226