0
What else can I help you with?
What is the plenum on a 2002 Kia Sedona?
The plenum is the intake manifold.
Where is the fuel injector located on a Kia Sedona?
The Kia Sedona is standard configuration gasoline engine. The fuel injectors are located at the top of the engine area and provisioned into the intake manifold/cylinder head assemblies.
I change the 3 top plugs but where are the other 3 spark plugs on a Kia Sedona 2005?
They Are under the Intake manifold like on my 04 kia sedona, You have to removethe center part of the manifold.
Where is the knock sensor on a Kia Sedona?
where is the knock sensor on 2003 kia Sedona answer knock sensor is mounted on the engine block near the intake manifold with a wiring harness attached to it.
What are the torque specs for 2002 Kia Sedona intake manifold?
The torque specification for the intake manifold on a 2002 Kia Sedona is typically around 16-22 lb-ft (22-30 Nm). It's important to follow a specific tightening sequence to ensure even pressure across the manifold. Always consult a repair manual for your vehicle or a professional mechanic for the most accurate information.
Where is the ERG valve located on a 2002 Kia Sedona?
The Exhaust Gas Recirculation (EGR) valve on a 2002 Kia Sedona is typically located on the engine intake manifold. To find it, look for a cylindrical component connected to the intake with a couple of vacuum hoses and electrical connectors. It's usually mounted near the back of the engine, making it somewhat challenging to access. Always consult a repair manual or guide for precise location and removal procedures.
Where are the spark plugs for 2005 sedona?
There are 3 in the front, but the other three, you have to take the intake manifold OFF the car,,, big job. Bob in AZ
Where are the spark plugs located in a Kia Sedona 3.5 Liter V6 engine?
You have to remove the intake manifold to get to the 3 rear ones. Search this forum, this question has been answered at length with full description of step by step method.
What is torque specs upper intake 2004 Kia sedona 3.5l?
The torque specifications for the upper intake manifold on a 2004 Kia Sedona with a 3.5L engine are typically around 11-15 lb-ft (15-20 Nm). It's important to follow a specific tightening sequence to ensure even pressure across the intake manifold. Always refer to the vehicle's service manual for the most accurate and detailed information.
Is there an easy way to change or replace the rear three spark plugs on my 2004 kia sedona they seem to be underneath the intake manifold any tips or advice would be greatly welcome thank you?
In my sportage I had to remove the intake manifold off to get at them (all 4) home it helps.
Where do you locate the engine temp sensor on a 02 sedona?
a temp sensor is located on the intake or the thermostat housing
Location of camshaft position sensor on Kia Sedona?
A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.
