0
What else can I help you with?
Where is the vacuum modulator located on a 1999 Chrysler Sebring 2.5 jxi?
The transmission does not have a vacuum modulator.The transmission does not have a vacuum modulator.
Does the 1994 s10 blazer havve a modulator valve?
assuming your talking about the transmission modulator...visually inspect the transmission and look for a vacuum hose from the engine to the tranny...
Where is the vacuum modulator on a 2001 Pontiac Montana?
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
Where is the vacuum modulator on a 1999 Chrysler Sebring 2.5l?
The transmission on a Chrysler Sebring does not have a vacuum modulator.The transmission on a Chrysler Sebring does not have a vacuum modulator.
Why would a 1995 Suzuki Sidekick down shift from 3rd to 2nd way too easily if a cable controls down shift points on the automatic transmission then what does the modulator valve do?
cable is demand vacuum modulator is vacuum which translates to LOAD> last is governor ,and this is speed bases (rpm at tail shaft) how is that.
How do you find a transmission vacuum modulator for a 1991 Chrysler new yorker?
The transmission in a 1991 Chrysler does not have a vacuum modulator.The transmission in a 1991 Chrysler does not have a vacuum modulator.
What is a vacuum modulator?
On some of the older vehicles the vacuum modulator controlled the shift points of the transmission by using the vacuum supplied from the engine.
How do you adjust a vacuum modulator?
I assume your refering to the vacuum modulator which controls transmission shift points. Remove the vacuum hose from the modulator. Using a small screwdriver, turn the screw inside the modulator. It may take several tries to get it right.
Where is the modulator valve on a 1994 Plymouth?
A 1994 Plymouth does not have a modulator valve.
Where is the vacuum line running to the transmission in a 1994 camaro Z28?
It's for a modulator valve. The later cars all shift by electronics and signals from the ECM. Yours however still uses a modulator valve and vacuum to assist in determining shift points.
What does a vacuum modulator do?
A vacuum modulator is used to apply pressure to the throttle valve. The modulator senses the pressure from the manifold and increases when the engine is under a heavier load.
Is there a seal at the end of the vacuum modulator?
There should be an o-ring where the modulator is inserted into the transmission. There should be no fluid where the vacuum line attaches, if so the modulator is bad.
