Headlight fuses for this generation Mazda 6 should be located in the engine compartment fuse box. Pull the lid off the fuse box and flip it over. There should be a diagram there etched in the plastic to tell you what each fuse is for.
Pull the fuse or just simply disconnet it.
remove the two nuts holding down the battery harness inside the fuse/relay center, then you can pull it out.
Hello: You can first try,,,looking for the fuse box,,,and see if there is a fuse for the ringing bell. Pull the fuse out,,,and the noise will stop.
Well, that light isn't directly controlled by a fuse - it's controlled through the engine ECM. To pull a fuse for the sake of disabling that light, you'd have to pull the ECM relay.. the problem is, you'd disable the ECM, in turn, disabling the car.
First locate the fuse box under the hood, in front of the battery. Then use a pair of needle noise plyiers to pull the ten amp fuse out. Get your new fuse place it in slot and make sure you press it in firmly.
You can either take out a spark plug on each rotor and spin it over or you can pull your fuel injection fuse and spin it over.
open passenger door, look on the side of dash. Fuse box cover is located there, Twist counter clockwise screw fastener by hand and pull off fuse box cover. Fuse box is located there.
To remove the fuse box from a 2004 Mazda 3, first disconnect the negative battery terminal to ensure safety. Then, locate the fuse box, typically found under the dashboard on the driver's side. Remove any screws or clips securing it in place, and carefully disconnect the wiring harnesses attached to the back. Once everything is detached, you can pull the fuse box out.
Disconnect your battery. /// Rather then disconnecting the battery which effects all the components, just pull the fuse (large fuse block in engine compartment) for the particular item you wish to reset,,, example: switch key to on position, pull injector fuse (30 amp), return key to off position and reinstall the fuse, this process resets the check engine lamp in most cases.
15 -------------- It's a 15amp Fuse located on the top left corner of the Fuse Panel inside the Cabin under the Glove Box. No tools needed, just undo the 'Shroud' with the 2 knobs, this will expose the Fuse Box , just pull it down and swap in a good fuse and you should be good to go.
The fuse block under the hood needs to be raised. There are four tabs around the perimeter of the block. There are 2 small bolts that hold the fuse in place. Remove the 10mm bolts then simply pull out the fuse and replace it, reinstall the bolts and place the fuse block back in place. There are sliding guides that will align the block.