If you have your owners manual check that, otherwise while the car is turned off take out each fuse and see if it's still good (the metal connector is still there). If there is nothing connecting the two pieces of metal it is blown. When you find the one that is blown. Look at the amps the fuse is. 5 10 15 20 25 30 or 35. Buy a new fuse that matches the same amount of amps and put it back in the right slot.
In a 1988 Mazda RX-7, the fuse that controls the dash lights and tail lights is typically a 15-amp fuse located in the fuse box. This fuse is often labeled specifically for "tail" or "dash" lights. It's important to check the owner's manual or the fuse box cover for the exact designation, as it can vary depending on the model and trim. If the lights are not functioning, checking and replacing this fuse may resolve the issue.
Check battery Check battery cables for corrosion or looseness Check fusable link
If the blinker and dash lights on your 2002 Mazda Protege stay on, it could indicate a faulty switch or a malfunction in the lighting control system. It's also possible that there is a short circuit or a stuck relay causing the lights to remain illuminated. Checking the turn signal switch and inspecting the fuses and relays may help identify the issue. If you're unsure, consulting a mechanic for a thorough diagnosis is advisable.
Center of the dash board you moron.
its under the dash on drivers side
do you have 2000 mazda 626 dash board?
Where is the fuse located that controls the inside dash lights on a 1993 Ford Explorer
it should be on the left side of the dash when you open the door
In a 1998 Mazda B2500, the fuse that typically controls the dash lights is often labeled as "Illumination" or "Dash Lights" in the fuse box. You can find the fuse box under the dashboard on the driver's side. If the dash lights are not functioning, check this specific fuse and replace it if it is blown. Always refer to the owner’s manual for the exact fuse location and specifications.
To replace dash lights on a Mazda B 3000 first disconnect the battery and remove the dashboard. Unplug the cluster wiring and carefully remove the display. Replace the lights.
Headlight switch (IT) controls the dash lights ALSO.Some have a fuseable link..ASSUMEING all the bulbs are g00d..
The flasher box in the Mazda MX3 is the plug in that controls the flashers for the turn signals and also the hazard lights. This part is located under the dash on the driver's side, just above the brake pedal area.