Hope this will help it happend to me. It was my cam sensor and the dealer fixed it for free.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
On the Daewoo Leganza it is located behind the AC compressor.
In the air tube just after air filter.
Mass Air Flow MAF sensor could be your, problem check that!
P1780 Push - Pull Sensor Mal, could you please explain what the push - pull sensor is please?
Here is a link for a parts place. http://www.partsamerica.com/ProductList.aspx?parttype=985&ptset=A&searchfor=Cam+Position+Sensor
cmp snsr will not prevent the car from starting,ckp snsr would.
Located behind the A/C Compressor. You will need to remove the P/S Pump, A/C Compressor then the bracket that holds them both.
AnswerThis code is related to the sensor switch on the Air Intake Unit. Check your cable under the hood of the car, make sure it is plugged in, when it is, clear the code and start the engine. The code should be gone. If the problem persists then you might have to replace the cable Owner of a Daewoo Nubira SE
In the Exhaust manifold at the front of the engine
Perhaps throttle plate is stuck? I have a Could 1997 Daewoo Leganza, every now and then the car goes into high revs each time I start it up, what I do is unhook the battery over night and this works, seems to reset some sort of sensor.
is located under the car. well under the engine.