you can try WD-40 on window edges, but usually need to take off door panel and check the cable. I had this happen to 3 out of 4 windows and the motors were ok but had to replace the cable arm they are about $60.00
Back and under vehicle.
It is under rear in back of xterra under the spare tire next to evap can.
I need to replace the back window of a 1999 Nissan Altima how do I do this
I had same problem on my 2000 Nissan Xterra. You probably need to replace the power window switch assembly. I did the same on my car and it works fine now. Go to http://catalog.nissanpartswholesale.com and look for part number O3060-177168 ($89.60). I'm not sure how far it goes back but there was a recall/service bulletin on my '01 Xterra for the same problem. They replaced all 4 of the assemblies at no charge. Might be worth a call to the local dealership.
Under the upper and lower intake manifolds at the back of the engine block.
The 2004 Nissan Xterra PCV valve is located on the outside of the air cleaner housing. The PCV valve can be found on the back of the air cleaner housing.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
The transmission dipstick for a 2003 Nissan Xterra is located near the back of the engine bay, on the passenger side. It is typically marked with a yellow or orange handle. To access it, you may need to remove any covering or insulation that obstructs it. Always ensure the vehicle is on a level surface and the engine is running when checking the transmission fluid level.
the only tools need are a 17 inch socket a rachet a "C" clamp to push the piston back in.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb. i don't need to change just the bulb. The entire light assembly must be replaced. The reflector is broken. i cannot get wires to release.
under the hood /front left hand side/back of battery/ under a black cover marked "fuses"