Usually two things happen. The key is worn out or the lock up is normal because of pressure on the locking system as you turn the key off. Try turning the wheel a half a turn to the right or left when you are parked then turn the car off and remove the key. If its the locking mechanism then this will fix that. If its the key then replace it.
how do remove the tailgate's window motor on a toyota 4runner 1997 ?
To disarm a 1997 Toyota 4Runner factory alarm, place the key in the ignition. Turn the key about halfway ensuring the car does not start. Leave the key in that position for 10 to 15 minutes and start the car.
No.
To reset the alarm system on a 1997 Toyota 4Runner, first, ensure the vehicle is unlocked. Insert the key into the ignition and turn it to the "On" position without starting the engine. Next, press and hold the "Valet" switch, usually located under the dashboard, until the alarm system indicator light blinks and turns off. This should reset the alarm system and allow you to start the vehicle normally.
none
Toyota Camry 97 uses electronic ignition system, and does not have distributor.
The 1997 Toyota 4Runner OBD 2 port is under driver side dash next to center console
The firing order for a 1997 Toyota 4Runner with a V6 engine is 1-2-3-4-5-6. This order helps ensure smooth engine operation and is crucial for proper ignition timing and engine balance. Always refer to the vehicle's service manual for specific details and maintenance information.
Most likely its an Ignition Switch/Cylinder issue unless you know that you have an alarm system that has the ability to lock the ignition switch. Other issues is that it could also be the Tumbler. If its stuck, best bet is to either call a locksmith and have them check it out, or have it towed to a garage that you trust.
every 130,000 miles :)
How to open gas cap toyota 4runner 1997
The 1997 Toyota 4Runner with the 6-cylinder, 3.4 liter V6 produces 150 horsepower at 4,800 rpm. This vehicle gets 15 miles to the gallon in the city and 19 mph on the highway.