0
The likely causes would be 1) plugged EGR valve: The valve gets plugged with carbon deposits over time and needs to be cleaned out. 2) a cracked air intake hose: The cracked hose causes air leakage which throws off the Mass Airflow Sensor, which when sending erroneous information to the computer can cause serious hesitation and stalling at idle.
What else can I help you with?
Where is the idle air control valve located on a 1999 Mazda protege with a 1.6 liter engine?
The idle air control valve is also known as the idle speed valve. On a 1999 1.6 literÊMazda Protege, it is located at next to the throttle body.Ê
1999 Mazda Protege will not idle?
It happened to me last week. Turned out to be the EGR valve that was not moving anymore. This valve is used when the motor is in idle which is why the motor was running almost fine when I was putting gas...
2003 Mazda Protege low idle?
9 times out of 10 is a your EGR valve stuck open due to rust, do a google search for protege low idle you'll find it! good luck
Why does your 1996 Mazda protege die when you take your foot off the gas it also wont idle?
Try the idle air control motor
What is the code p0507 mean on a 02 Mazda Protege?
Higher then expected Idle, at least 200 RPM. May be a vacuum leak, a dirty Idle Air Control valve.
How do you set idle speed on a 1996 Mazda Protege?
To set the idle speed on a 1996 Mazda Protege, first ensure the engine is at normal operating temperature. Locate the idle air control (IAC) valve, which is typically on the throttle body, and check for any vacuum leaks or issues. If adjustments are necessary, you may need to use a scan tool to reset the IAC learning procedure, as the idle speed is electronically controlled. Always refer to the vehicle's service manual for specific procedures and specifications.
What is a code p1345 on a Mazda Protege?
it is a camshaft position sensor check vaccume lines also as for some reason this will throw this cone because of rough idle
Why is your Mazda tribute stalling out when you idle?
Your Mazda Tribute may be stalling out while idling due to several potential issues, such as a dirty or failing idle air control valve, which regulates engine idle speed, or a clogged fuel filter that restricts fuel flow. Other possibilities include vacuum leaks, a malfunctioning mass air flow sensor, or issues with the ignition system. It is advisable to have a mechanic diagnose the problem to ensure proper repairs are made. Regular maintenance can also help prevent such issues.
Mazda 6 won't idle New pump been fitted Still stalling Any ideas?
I had the same prob, turns out it was a vac hose that needed to be replaced not the fuel pump
Why does my 95 Mazda protege smoke and idle above 3 rpm's when first cranked?
if you find a answer on the idle issue let me know my 95 does the same thing as far as smoking mine does that too when its cold out i was told it was the valve seals r bad
Ford Focus stalling at idle?
ford focus stalling at idle but not cutting off the check engine light is on please help so i dont get rip off thanks
Why does your 02 protege idle low to the point where the engine almost dies?
Why is that my idle is low what cost that to do it
