There are multiple reasons, most likely you have a damaged wire somewhere. Because you know the fuse you can track the wiring around that fuse. Test for the ground.
Not a good thing to do! If you are blowing 10 amp fuses, you have a problem with that circuit. Putting a 30 amp fuse in its place can do more damage.
No, you cannot replace a 10-amp fuse with a 20-amp fuse. Fuses are meant to guard your wiring and equipment by melting or 'blowing' before the wiring, itself, melts and causes a fire. It is safe to use a smaller fuse than called for, but never, ever is it safe to use a larger fuse than called for.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
A 3 amp fuse sounds pretty small for that application. I would suggest at least a 5 amp, and probably a 10 amp.
no you can't
Another 10 amp fuse. If you use anything larger, you can fry your equipment, cause a fire, and so on. If this fuse is blowing all the time, there is a short in the component or wire.
When I had this problem with my 1999 Toyota Solara, the issue ended up being a faulty oil pressure sender unit. The 2001 Toyota Camry uses the same engine (and very likely the same sending unit) as the 1999 Toyota Solara.
No.
If the 1990 Chevy Lumina is blowing the DIS 10 Amp fuse when the ignition is on, check to make sure that all wires coming from this fuse are grounded properly. Also check to make sure the starter is wired properly. There could also be a loose wire in the dash near the ignition.
( # 4 ) is a 10 amp fuse for the left headlamp , ( # 8 ) is a 10 amp fuse for the right headlamp and ( # 33 ) is a 15 amp fuse for the high beam headlamps
7.2kW shower = 32 Amp fuse = 6 mm2 cable size7.5kW shower = 40 Amp fuse = 10 mm2 cable size8.5kW shower = 40 Amp fuse = 10 mm2 cable size9.5kW shower = 40/45 Amp fuse = 10 mm2 cable size10.5kW shower = 45 Amp fuse = 16mm2 cable size
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.