A gas smell and difficulty starting in your 1990 Toyota 4Runner could indicate a fuel leak, a failing fuel pump, or a clogged fuel filter. Fuel injector issues or a malfunctioning carburetor could also contribute to these symptoms. It's important to inspect these components and check for any leaks in the fuel system. Addressing these issues promptly is crucial for safety and to prevent further damage.
because its cold
To disarm a 1997 Toyota 4Runner factory alarm, place the key in the ignition. Turn the key about halfway ensuring the car does not start. Leave the key in that position for 10 to 15 minutes and start the car.
oil in intake
To reset the maintenance light on a 2007 Toyota 4Runner, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine to ensure the maintenance light is reset. If done correctly, the light should no longer be illuminated.
To reset the maintenance reminder on a 2017 Toyota 4Runner, start by turning the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off and start the engine to ensure the maintenance light has been reset. If done correctly, the maintenance reminder should no longer be displayed.
Is this an automatic or manual transmission?
Define not start?
that sounds like i ground in the bake by the lights or if it has a trailer plug i would start their
The fuel filter is clogged and needs replaced. The second problem could be the fuel injectors are not pumping sufficient fuel to the engine.
To reset the power windows on a 2000 Toyota 4Runner, start by ensuring the ignition is in the "ON" position. Fully lower the window using the switch, then hold the switch in the down position for a few seconds after it reaches the bottom. Next, raise the window fully while holding the switch up for a few seconds after it reaches the top. This process helps recalibrate the window's automatic function.
To change the antenna motor in a 2000 Toyota 4Runner, start by removing the interior trim panel around the antenna base to access the motor. Disconnect the wiring harness and unbolt the old motor from its mounting bracket. Install the new antenna motor by securing it in place, reconnecting the wiring harness, and then reassembling the trim panel. Finally, test the antenna to ensure it operates correctly.
the symptoms you describe sound like a starter problem. replace it and your problems will be through!