0
Why don't you get a spark on 2 and 3 cyls 1996 Mazda Miata if both coils are good?
If you are positive its 2 & 3 , and you know the coils are good , check the crank/cam angle sensor . I had this problem with 1 & 4 cyl. I WAS NOT able to test the cam sensor at home , myself. So I replaced it with a working one from a friends car . Cured . Bought one from junk yard next day , they are VERY expensive.
What else can I help you with?
What is the tire pressure on a 1996 Mazda miata?
26 psi
What is the oil capacity for a 1996 Mazda miata?
4 quarts
Will seats out of a 2000 Mazda miata fit in a 1996 miata?
Should, I believe you will have to switch the seat frames though
How many quarts of transmission fluied for a 1996 Mazda miata?
2 quarts
What is the button below the hazard button on Mazda miata 1996?
it is to cange the headlamp
What is the Spark plug gap for a Mazda familia 1996?
The spark plug gap for a 1996 Mazda Familia should be set between 1.0 and 1.1 mm. This is stated in the adjustment data from Mazda.
Where is the airbag module located on a 1996 miata?
The airbag module on a 1996 Mazda Miata is located along the front of the vehicle's frame. It is positioned so that it can immediately detect impacts and deploy the airbags.
1996 Mazda Miata windshield washer won't work Is there a fuse for this?
there is . make sure the resivoir is filled up
Ignition firing order for a 1996 Mazda miata mx5?
4-1-2-3 Regards Sal
Does the 1996 Mazda miata have a interference motor?
No it does not, it is a non-interferenceif the timing belt break the valves will not collide into the pistons.
How much oil does a 1996 Mazda Miata hold?
Standard 4 quarts can be used for an engine oil change.
How do you change spark plugs on a 1996 Oldsmobile Aurora?
To change the spark plugs on a 1996 Oldsmobile Aurora, first, disconnect the battery to ensure safety. Remove the engine cover if necessary, then locate the spark plugs, which are typically beneath the ignition coils. Unscrew the ignition coils, carefully pull them out, and then use a spark plug socket to remove the old spark plugs. Install the new spark plugs, ensuring they are properly gapped, reattach the ignition coils, and reconnect the battery.
