I have a 2000 Leganza and it would not shift out of park/gear recently. I discovered it was a bad brake switch with signals the brake lights to activate and the shifter to release. The switch is a small plug-type part and I found a used one on line for about 30 bucks. labor to put it in was about 50. !
rjemay@msn.com
I had same problem years ago - there was a recall on the brake light switch - you may be able to get it replaced for free?
In case you get stuck though and need to get it home - stick a screw driver into the slot next to your shifter to get it into gear. Get the switch fixed though - your brake lights may not be coming on.
I read in another forum that it might be the brakelight switch that is making the shift lock, lock up.
piston 4 is the nearest to transmition gear
How do you remove the gear shift knob on a 2000 Daewoo Lanos?
I have the 2000 model are you talking about rev/neu/ drive/ park gears?
3 very quick and obvious things that will tell you the TPS is operating correctly. 1) If no signal is being received, the transmission will stay in 3rd gear and will not shift. 2) If high voltage exist, the transmission will shift very late if at all but will take of in 1st gear. 3) The check engine light will be on.
check your cross member on the gear selector it sometimes pops off
Most likely on the gear shift under the handle on the righthand side.
To make a reverse shift in a Daewoo Espero, first come to a complete stop and ensure the gear lever is in the neutral position. Then, press the brake pedal and shift the gear lever to the "R" (reverse) position. Release the brake slowly while applying gentle pressure to the accelerator to move backward. Always check your surroundings before reversing to ensure safety.
it just puts the car in the lowest gear (2nd) In the hold the car will set of in second. mainly used to reduce torque to wheels to reduce wheel spin
Cable too slack.
depends.firstly you need to have the system read with a scan tool to interpret codes,could be anything from wheel speed sensors to broken teeth on ring gear or abs unit itself.
If your not starting in low gear check the little snow flake button next to the gear shift. If this has been pressed your starting in 3 rd. gear.