answersLogoWhite

0

Either your handbrake switch is broken and will not turn off or you have low brake fluid.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the reverse light switch located on a 1993 Mazda 626?

The 1993 Mazda. reverse light switch is located below the shifter column. The relay switch can be seen by removing the center console.


How do you adjust 1993 Nissan Micra handbrake?

Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks


Where can you find a fuse box map for a 1993 Mazda 929?

WHERE IS THE FUSE BOX IN MY 929 MAZDA AND WHERE. HOW DOES THE ENGINE CHECK LIGHT LOOK AND LAST WHY IS IT ON AND STILL RUN


Where is the inertia switch on a 1993 Mazda mx3?

A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.


Why would a 1993 Mazda mx6 slip out of gear intermittently?

5 speed or automatic?


How do you adjust the handbrake for xjs 1993?

When all else fails, check your Drivers Handbook.


Why would a 1993 Mazda 626 smell like burning oil or gas?

it leaks oil.


1993 Mazda miata parking lights are on all the time after servicing the battery?

Check the rear light wires, could be a short


Is the 1993 Mazda rx7 a lemon?

No.


Will a 1991 Mazda 5 speed transmission intercahnge with a 1993 Mazda 626 transmission?

Unfortunately these are not interchangeable. The 1993 model was a complete retooling of the 626, a bad one at that....the 1991 had an excellent transmission, the 1993 through 1998 were all terrible. In theory, you could retrofit, but that would be expensive.


What oil weight for 1993 Mazda Miata?

I use 5-W30 in my 1990, and since the 1993 is almost as old, I would recommend the same oil weight.


How do you locate starter solenoid on Mazda 626 1993 on Mazda 1993 626 fwd?

Follow + battery cable should connect to solenoid