0
yes but you need to modified. this is for a complete body swap. prior to install tacoma cab on 89-94 frame you must une a 3in body lift to clear gaz tank because the tank are other side of tacoma, the rear body mount fit direct the second in the front of door must be slotted 1\2 in per side. and for the front under the radiator you must drill 2 new holes really easy. the stering colum must be removed and use older shortened rod. for the bed ,tacoma use 6 bolt and older 8. you must extend 2in rear frame and make a plate 11in x 3in and bolt them to the frame dril an hole in center. now the last thing is the fuel door is o the wrong side me i prefer make a long tube to fill the tanks by the other side or you can sheve them and reintall them on the left.
What else can I help you with?
Is a 87 Toyota frame the same as a 93 Toyota?
Does a toyota 4 runner have the same frame as a toyota tacoma
How come the 1994 Toyota 4 runner was not recalled for frame rust problems Didn't the tacoma and 4 runner use the same frame?
No, different frame.
How can i get a 2001 Toyota Tacoma chassis or frame to buy?
You tried eBay? They're good, there are many other sites that you can buy used cars of though.
Your 1999 tacoma has started to rust on the frame Is there anyone out there that has this same problem?
there are tons of people with this problem that got a lot of money from Toyota for this problem. Its called tacoma buyback program. look into it, i got 11,100 $ for a truck i pai 5500$ for.
Where is the fuel filter on a 2001 Toyota Tacoma?
It is located under the vehicle, passenger side, below bed, rear frame rail, mounted in fuel line.
Where are the hidden vin numbers for a Toyota Tacoma?
location is under the frame, you need to check on your local DMV to see if they match with the visible numbers (dash and doors)
Where is the fuel filter located on a 2000 Toyota Tacoma extra cab?
Its on the inside of the frame of the truck between the cabin and the bed. it is not on the inside of the frame of the truck between the cab and the bed. it is under the intake manifold on the drivers side of the block.
Will 92 tacoma 4x4 body fit on 88 Toyota 4x4 pickup?
The body of a 1992 Toyota Tacoma 4x4 is not a direct fit for an 1988 Toyota 4x4 pickup due to differences in chassis design, dimensions, and mounting points. While some components may be interchangeable, significant modifications would be required to make the Tacoma body fit on the older pickup's frame. It's advisable to consult with a professional or refer to detailed specifications for both models before attempting any swaps.
Where is the transfer case control module located in 2002 Toyota Tacoma?
In a 2002 Toyota Tacoma, the transfer case control module is typically located under the vehicle, near the transfer case itself. It may be mounted on the frame or on the transfer case housing. For precise location details, consulting the vehicle’s service manual can be helpful, as it may vary slightly based on specific configurations.
Will insurance total a 2003 Toyota Tacoma if the frame is bent but there is no cosmetic damage?
How can you bend the frame without cosmetic damage? Did you run over something? Depending on your insurance coverages, if a vehicle has a bent frame and is no longer safe to drive, then an insurance compamy would usually total out a vehicle. Otherwise, they can pay to repair the vehicle.
Where is the fuel filter located on a 2001 Toyota Tacoma Reg Cab?
It is located under vehicle, passenger side, below bed area, passenger side rear frame rail, mounted in fuel line.
Where is the fuel filter located on a 1997 Toyota Tacoma 2.7L?
Most all fuel filters now regardless of make are located on the drivers frame rail underneath the car midpoint between the tank and the engine. ..1930fcoupe
