0
What else can I help you with?
How do you reset the check engine light on a 2000 Subaru Forester?
With the proper scan tool.
How do you check the transmission fluid level on subaru forester?
I want to check the level of atf temp in my subaru forester 2010. On checking the transmission fluid level, after the car was driven about 10 km and was put in each gear and setting the select level in the "p", do i have to turn off the engine or idle the engine before i check the atf level?
My Subaru Forester 2002 does not start properly in the mornings since the check engine light came on What do you do?
Have vehicle scanned to determine the problem
When accelerating 2005 Subaru Forester Check Engine Light came on then went off?
you need a scanner to scan your cars computer to see what is causing it to happen
How do you you make it so the door locks on a 2004 Subaru Forester do NOT lock when the engine starts?
I had the same problem on a '99 Forester. It was cured by altering the code number on the alarm system. Check the booklet that came with the vehicle for details.
Why won't the sunroof on my 2001 Subaru Forester open?
The first thing to do is check all your fuses.
Where can I get an owners' manual for the 2004 or 2005 Subaru Forester XT model?
you could check on eBay first, but your best bet is a subaru dealer
Why does the heater go cold in your 1998 Subaru Forester?
My heater doesn't go cold. But to answer your question, check the engine coolant level in the radiator. Be sure that the engine is cold before removing the radiator cap. --Ken
Why Subaru 2003 Forester Check Engine Light stays on?
You have a problem with the engine controls, have the codes read at the dealer or an auto parts store and make the necessary repairs and the light will go out, or it can be reset by the tech.
How do you check transmission fluid subaru forester 2014?
To check the transmission fluid in a 2014 Subaru Forester, first ensure the vehicle is on a level surface and the engine is running at normal operating temperature. With the engine running, locate the transmission dipstick, typically found near the back of the engine bay. Pull the dipstick out, wipe it clean, reinsert it, and then remove it again to check the fluid level; it should be within the marked range. If necessary, add the appropriate type of transmission fluid as specified in the owner's manual.
Check engine code 33 on a 1991 subaru legacy?
Code 33 means: Vehicle speed sensor (VSS) or circuit
How do you reset check engine light in 2003 subaru forester?
To reset the check engine light in a 2003 Subaru Forester, you can disconnect the negative battery terminal for about 15 minutes. This will clear the vehicle's onboard computer and potentially turn off the light. Alternatively, you can use an OBD-II scanner to clear the trouble codes that triggered the light. However, it's important to address the underlying issue that caused the light to come on to prevent it from reappearing.
