0
What else can I help you with?
How to fill transmission on 1992 Ford Fiesta?
By putting a funnel into the dipstick tube.
What are the uses of a tube?
a tube is for putting things in if has a lid
Where does the oil go in for a 1998 ford expedition?
The motor oil, in your 1998 Ford expedition, should be put in the oil fill tube. The oil fill tube should have a That labels it as the oil fill tube.
How much sand to fill a tube that 5 inches wide 10 inches long and 3 inches tall?
Volume of a tube 5 inches wide 10 inches long and 3 inches tall is 150 cubic inches
Where is the transmission fill tube located on a Jeep Cherokee?
Under the hood towards the back of the engine is the trans dipstick tube. You use this tube and a funnel to fill the trans.
Why does my toilet fill tube keep running?
Your toilet fill tube may keep running due to a faulty fill valve, a leak in the flapper valve, or an issue with the float. These components may need to be adjusted or replaced to stop the continuous running of the fill tube.
What will happen if you heat few grains of clean sand in a test tube?
Try it and you'll find out !
What is a tube of sand formed by lightning?
A fulgurite is a tube of sand that is formed when lightning strikes the ground, melting the sand and forming a glassy tube-like structure. This occurs when the intense heat of a lightning strike fuses the sand particles together. Fulgurites are often found in sandy areas like beaches or deserts.
How do you get water in a camper?
There is a fitting on the outside of your camper or a fill tube. Just put a gardenhose on the fitting for a hose or open the fill tube and pore in water.
How do you fill a filter with sand?
Very carefully! Make sure the laterals are in good condition and tight. If the filter has a verical return tube cover it to prevent sand from entering. Make sure this tube remains in the center of the opening. Add water to the empty filter until it is half full. This helps protect the laterals from being damaged by the addition of the sand and helps to distribute the sand evenly. Slowly add the correct amout of sand to the filter. There should be a label on the side of the filter that specifies the type of sand and the amount required. After the correct amount of sand is in the filter remove the cover from the return tube. Re-assemble the filter. Move the valve to "backwash" position to finish filling the filter with water. Backwash until water in the sight glass is clear.
What is the tube used for?
putting chemicals in and construing an experiment
Transmission fill 98 sunfire?
You normally fill the transmission by way of the dipstick tube.
